Deutz 914 Informations techniques télécharger pdf (Page 58)

Never fill collector bowl with oil. Replace

collector bowl if damaged.

● Undo wing nut 1 and remove cover 2.

● Remove collector bowl 3 from lower sec-

tion 4 and empty. Clean leaves, straw and

other foreign matter from lower section of

pre-cleaner.

● Reposition collector bowl 3 onto lower

section 4, fasten cover 2 in place by

tightening wing nut 1.

● Turn engine off and wait about 10 minutes

for the oil to drain from filter housing 1.

● Loosen quick fasteners 2 and remove oil

cup 3 with filter element 4; if necessary,

loosen filter element with the aid of a

screwdriver at the separating point. Do not

damage rubber gasket 5!

● Remove dirty oil and sludge. Clean oil cup.

● Clean filter element 4 in diesel fuel and

allow to drip-dry.

● Clean filter housing 1 if very dirty.

● Inspect and replace rubber gasket 5 and 6

if necessary.

● Fill oil cup with engine oil up to the mark

(arrow) (for viscosity, see 4.1.2).

● Refit oil cup and element to filter housing

and secure with snap clips.

Never clean filter with gasoline!

Dispose of old oil in accordance

with environmental regulations!

Service and Maintenance 6.4 Combustion Air Filter

6.4.2 Emptying Cyclone Type

Precleaner

6.4.3 Clean Oil Bath Air Filter

1 2 ... 53 54 55 56 57 58 59 60 61 62 63 ... 84 85

Pas de commentaire

Deutz 914 Informations techniques Page 58