Deutz 1012 Spécifications télécharger pdf (Page 154)

Service Training

Section 4.4

Page 10

4.4.4.3 STEERING CYLINDER REMOVAL AND INSTALLATION

STEERING CYLINDER REMOVAL

- Jack up and securely block the rear of the truck so that the wheels can turn freely.

- Remove the dowel pins (3) from pin (2).

- Turn the steering wheel clockwise or anti-clockwise until the steering cylinder is extended as far as

possible.

- Remove the four mounting screws (9) at the steering cylinder (7).

- Pull the steering cylinder (7) to the rear and so that the pin is positioned under the counterweight recess.

NOTE: Support up the steering cylinder with wooden blocks.

- Position the pipe (1) over the pin collar and support it against the counterweight recess. Place the jack

(5) on the ground, put the press-out pin (4) on the piston of the jack (5) and bring them in line.

- Operate the jack (5) to press out the pin (2).

- Press out the pin on the other side of the steering cylinder as described above.

- Disconnect hoses (6) and (8) at the steering cylinder.

- Remove the steering cylinder (7).

1 2 ... 149 150 151 152 153 154 155 156 157 158 159 ... 281 282

Pas de commentaire

Deutz 1012 Spécifications Page 154