Deutz 914 Spécifications télécharger pdf (Page 43)

Belt drives Servicing and maintenance works

Checking the belt drive

Check the whole belt drive visually for damage.

Renew damaged parts.

Remount protective devices if necessary.

Pay attention to correct fit of new belts, check the

tension after running for 15 minutes.

Only carry out work on the belt drive with

the engine at a standstill!

Always change both belts in sets in case of

wear on the double belts or damage to one

V-belt.

After repair work: Check that all guards

have been replaced and that all tools have

been removed from the engine.

Checking the belt tension

Lower indicator arm (1) into the measuring de-

vice.

Place guide (3) between two belt pulleys on the

V-belt (2). The stop have to be at the side.

Press the button (4) at right angles to the V-belt

(2) evenly until you hear or feel the spring snap

in.

Lift the measuring device carefully without alter-

ing the position of the indicator arm (1).

Read the measured value at the point of inter-

section (arrow), scale (5) and indicator arm (1).

If necessary, re-tension belt and measure again.

Tools

Belt tension measuring device

(order number:

8115)

can be obtained from your DEUTZ partner.

Change the belt

Fan

Press clamping roller (1) in with conventional tool

to change.

Remove belt and fit new one.

Checking the belt tension (



43).

OBJ_DOKU-16314-001.fm Seite 43 Donnerstag, 24. Juli 2008 11:18 11

1 2 ... 38 39 40 41 42 43 44 45 46 47 48 ... 63 64

Pas de commentaire

Deutz 914 Spécifications Page 43